Tighten Door Handle Sub Zero

Remove the screws from the side mounting brackets.

Tighten door handle sub zero.

Remove the panel by pulling down and out to release the panel mounting tabs from the drawer. It is between. Tighten the handle screws from the back side. There is no direct metric equivalent for a 3 32 allen wrench.

Don t over tighten as they strip easily because they are so small. If the end caps are tight to the door and the handle is loose service is needed. Remove the screws from the side mounting brackets. Remove the handle by removing the set screws from the underside of both handle standoffs.

Handle only is loose tighten the set screw on the bottom of the handle standoff with a 3 32 allen wrench. A 3 32 allan wrench is needed to tighten the set screw on a sub zero stainless steel handle. There should be a small set screw on the inside of the handle opposite side of the picture. Once the handle and standoffs are removed from the door tighten the standoff mounting stud with a flat head screwdriver.

This may be part of an allan wrench set or can be purchased through a local hardware store. Use whatever screwdriver or wrench is appropriate to tighten this screw and firm up the doorknob s grip on the spindle. The door must be partially disassembled to tighten the handle. See also sub zero 700 series panel removal.

Remove the molding trim from the hinge side of unit or bottom of drawer. This is usually driven with a small allen key. This video is about removing and re installing asub zero handle. Remove the molding trim from the hinge side of unit or bottom of drawer.

Refer to the images above. Remove the magnetic caps covering the side mounting brackets. Contact factory certified service to schedule an appointment for repair. For allen wrench information see wrench size used to tighten a sub zero handle.

Designer formerly integrated series remove the molding trim from the door or drawer. Both l shaped and flat allan wrenches can be used. Remove the magnetic caps covering the side mounting brackets. A small amount of blue loctite may also prevent the mounting stud from loosening in the.

Remove the panel by pulling down and out to release the panel mounting tabs from the drawer. The handle on a wolf range or wall oven should not be loose.